Fargo 82600 0.6 mil PolyGuard Laminate - 250 imprints Details
Genuine Fargo 82600 0.6 mil clear laminate decreases wear-and-tear on your printed cards, protects them from fading, and increased card durability by adding a layer of protection to them. (Note: laminate is sometimes also referred to as overlaminate or overlamination.)
In order to laminate a card with the Fargo 82600 laminate, a printer with lamination capability is required.
To maintain the warranty on your Fargo printer, optimize the use of your printer, and maximize the quality of your printed cards, use only genuine Fargo 82600 laminate ribbons.
Did you know that Fargo 82600 laminates have a shelf life?
Laminate ribbons typically have a shelf life of up to one year, when stored under the proper conditions. Laminates that are not store properly, and are more than one year old, will not print optimally and will likely end up costing more time in maintenance and more money in reprinting cards.
As an authorized Fargo reseller, ID Zone guarantees that our genuine Fargo 82600 clear laminates are stored properly and are always 'fresh',
How to find the shelf life?
Look for the manufactured date on the sticker on the box, which is above the part number. If this date is over one year in the past, then your ribbon is past its shelf life.
Fargo's PolyGaurd 82600 lamination material is a secure, tamper-resistant overlaminate. PolyGaurd laminates provide exceptional durability with independent tests showing cards protected with PolyGuard overlamination can withstand 50,000 swipes through a magnetic stripe reader before showing signs of wear. This is compared to competitive cards, where, only after 300 swipes, the cards began to show wear.
PolyGuard is an ideal choice for applications that require a long, highly secure card life.
Fargo 82600 0.6 mil PolyGuard Laminate - 250 imprints Specifications
- Manufacturer and item#: Fargo 82600
- Clear patch overlaminate
- 0.6 mil thick
- Approximately 1/16" border from patch to card after lamination
- 250 imprints per roll
- For use with the following Fargo lamination modules cartridges 1 or 2:
Note: All HDP5000, DTC4500, DTC4500e and HDP8500 lamination modules utilize a cartridge system to load overlaminate materials. A HDP5000, DTC4500, DTC4500e and HDP8500 single-sided lamination module utilizes only cartridge 1, while a duplex simultaneous lamination module utilizes cartridges 1 and 2.
Please Note: Fargo has updated the RFID technology used with this ribbon which may require you to update your firmware. See the complete details on this upgrade on our Fargo Ribbon and Laminate RFID Tag Update page.